1. disassembing process and installation process are opposite,when disassembling,pls follow revesal installation process. 1拆卸和安装过程。过程相反，拆卸时，请按照倒置安装过程。 2. in order to avoid has the damage, not in the unfinished before removal,optionally rotate outside unit, indoor unit and hanging board. Pay attention to protect the FPC cable soft. 2。为了避免发生损坏，不在未拆除前，随意转动外机，室内机和挂板。注意保护FPC电缆软。 3. removing indoor unit, all should be even harder to pull out 3。去除室内单元，都应该更努力地拉出来 Fault solution and precaution 故障解决和预防 1. operating temperature range:-25℃-+55℃ 1。工作温度范围：25℃+ 55℃ 2. shoud use the standard (AAA)batteries, old and new batteries shall not be used together 2。应使用标准（AAA）电池，新旧电池不能一起使用 3. do not use this product to fall on the ground or from the strong beat 3。不要使用本品倒在地上或从强烈的拍子 4. avoid the position light(like the sun lights),if not easy to cause too bright or pull light phenomenon(this is not a fault),will also affect the camera life 4。避免位置灯（如太阳光），否则容易引起太亮或拉光现象（这不是故障），也会影响相机的效果 5. to avoid subjecting moisty,dusty,extremely hot,cold,strong electromagnetic radiation Etc 5。避免使潮湿，灰尘，非常热，冷，强烈的电磁辐射等 6. unless indicated otherwise,not to open machine,if there is fault to repair,please contact with the dealer. 6。除非另有说明，不开机，如有故障维修，请与经销商联系。 Precautions 注意事项 1. can not boot or boot immediately after the automatic shut down 1。无法启动或启动后立即自动关闭 fault reason: check that you have accurate installation od standrad AAA batteries 故障原因：检查是否已正确安装OD标准AAA电池 2. image display a pale or blurred 2。图像显示苍白或模糊 Fault reason:lens by strong light or the light is too dark 故障原因：强烈的光或光镜头太黑了 |